Hi Gaston & List... I'm sure not the one to be getting advise from, but I'm glad to share my experiences and thoughts on CS. The following pertains to Gaston's posting that's below.
1. I don't use a starter other than a few ounces of my previous batch, and I sometimes forget that. For several years prior to joining this list I was adding a drop or two of very dilute sea salt solution as some web pages have suggested. In about twenty minutes I had a somewhat gray solution. We drank it and it seemed to work (no colds etc.) and we didn't turn gray. It seemed to work as well (or better?) on cuts and scratches as the clearer solution. However, the arguments on the list convinced me to switch over to the slower method, particularly for silver taken internally. 2. and 3. I don't have CS test instruments YET beyond an ammeter/VOM so I don't know what PPM or uS it is yet. Will post when I know. CS gets used up pretty fast here so it doesn't sit around long, but I haven't noticed any plating out in the bottles I use. Concerning current flow differences and recommendations; that probably has something to do with the surface area of the electrodes. I use a silver round which has a lot more surface area than a silver wire, hence more current doesn't necessarily translate into a higher current density at any specific point on the anode. I just started a batch of CS and the starting current using the round was about 1.1ma. Then I unplugged the round and plugged in the 3" long #14 silver wire I used to use and the current dropped to 120uA. There seem to be many ways to make good (and bad) CS. I think if one can make ANY CS they have an important tool, and then we can work to refine and make it better. I don't think anyone should hold off making CS because they are afraid they won't make it right or something. (I know this doesn't apply to you Gaston, but once I start commenting it's sometimes hard to stop:). Ron "G. Boucher" wrote: > > Hi Ron > > Good to hear from you on CS. > > I am new to the CS and I would like to know from your experience: > > 1.- Do you use any starter to produce your cs other than > a mixture from the previous batch ? > > 2.- Do you know the strength of your CS in either PPM or microSiemens ? > > 3.- Do you notice a decrease in PPM or Microsiemens 24 hours > after production ? > > I normally read 0.15 MA with distilled water at the start and heated > I read around 0.25 to 0.35 MA. > > It is interesting to hear that you see T. E. at around 6 MA. Many > CS producers recommend to use a limiting current of 0.8MA > to produce cs. Does that mean that T. E. is not present with that > kind of low current ? > > >From what I read, apprarently, low current is better to produce > small particles. It seems to take longer to prduce CS with a low > current and this is probably why we do get yellow CS. > > <snip> > -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>

