Janine, and all interested list members.
                                    Please be advised this is a circumstance I
can not address professionally, as we do not give medical advice or any form of
medical consultation.
                        I can, however, make a few observations that may be of
some value to you in your personal researches.  First, we have found that
several factors have to be in place....and acting in concert, to yield
satisfactory results----from among  our volunteer experimental populations.  We
found it essential that:  (1) The colloidal silver employed MUST be of the
proper particle size ( the ppm concentration was less of a factor).  (2)  A
MSM/DMSO mixture of approximately 80% MSM and 20% DMSO was needed as an
effective penetration/transport mechanism.   (3)  Pure oxygen was required as
the gas-drive.  (4) The mist-particle size was of consequence, also.  The finer
mist clouds, driven at higher pressures (30 to 35 psi) seemed to carry further
into the lower pulmonary regions before terminal attachment.
                In all circumstances where we were unable to get the CS solution
into direct contact (across the mucosa-ladened barrier), we had only limited
success.
                Assuming you successfully generated a CS x pathogen interface, I
am deeply puzzeled by your announced results.  I can offer no further comment on
this circumstance.
                                        Sympathetically yours. Brooks Bradley.
p.s.  The inhalation technique was, also, of some consequence.  Deep, slow
inhalations where the volunteer discharged the mist for approximately 4 or 5
seconds, shutting it off while continuing the inhalation to the count of
8.....seemed the ideal.  If the volunteer had insufficient lung capacity to
maintain an 8 second inhalation, the ratio should be maintained at 50% airbrush
ON and 5O% Off for scavenge breathing (completing the inhalation) for whatever
their inhalation time constant is.  e.g.  6 seconds> 3 seconds on for airbrush
discharge, and 3 seconds continued inhalation after airbrush shut-down.


GaryJanine wrote:

> Brooks,
>
> I constructed the nebulizer with your instructions and used it 2 weeks or so
> ago, I didn't have a cold but my kids did and I tried it out too. Ever since
> then I have had a sore throat that won't go away, any thoughts on what could
> have caused this and how to get rid of it? Thanks for any help(I know you
> are quite busy) Also, I didn't really see any improvement after using the
> nebulizer and my kids are still coughing.
>
> Janine
> [email protected]
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> To join or quit silver-list or silver-digest send an e-mail message to:
> [email protected]  -or-  [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
>
> To post, address your message to: [email protected]
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
> List maintainer: Mike Devour <[email protected]>