In a message dated 00-05-16 17:18:40 EDT, you write:

<< When ionic cs
 is made the ph lowered a little which is why one can't use a standard
 TDS unit with it. The time vs ppm chart that came with it is fiirly
 accurate. The ionic cs is much more powerful than the non-ionic. A 10
 ppm cs made with your unit is equivalent in bacteria killing power of
 about 1000 ppm dc or non ionic cs. you can make non ionic cs by putting
 both electrodes in the water >>

I can't speak to using conductivity of other analytical techniques to measure 
the silver concentration, but from my experience it may be possible to make 
three different types of CS because you can alter the HVAC process at least 
three ways.

(1)The first way is to have both electrodes in the water. The production rate 
is very slow.

(2)The second way is to have only one electrode in the water while the second 
electrode is above the water which forms an arc. The production rate is 
probably faster, but I've never actually measured the difference in 
production rate between (1) & (2).

(3)The third way is to use the same set-up as in (2), but by varying the wire 
diameter, selecting the height the electrode is above the surface, and 
carefully manipulating the power supply voltage, you can begin to melt the 
silver and "sputter" it off the electrode surface. The production rate here 
is probably 100 or more times faster than (1) or (2) and you can make any 
concentration you want (into the hundreds of ppm) that is completely stable 
over time. Another bonus is that you don't have to use distilled water if 
you're in the pinch (although I never considered using anything else).

Roger Altman


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>