Hi,
I was hoping that someone could help a person with minimum tech 
understanding (me<G>).  I have two CS generators, one that I purchased made
with 1 nine volt battery where the silver electrodes are soldered directly
to the battery cap connector ends, and the second one I made that uses the
three 9v batteries where the connectors are soldered in series to two
alligator clips.  I want to check the connections, since both seem to be
working not quite as effectively as in the past, and the batteries are new.
I bought a simple multitester multimeter device from Radio Shack (with which
I checked the batteries).  I believe that to test the resistance of both
generators (Rx1K Ohms is the function  per the manual) will verify that the
connections are good.  However, I'm not sure, and was wondering what the
proper way to do the test is and which part of the generator I should
connect the tester leads to  - the battery cap connector nodes or the
electrodes (on the direct solder generator)/ alligator clips.  Also, what
should I be looking for? (When you set the Rx1k Ohms function, you touch the
positive and negative leads together, the meter goes to zero.  If it is
working, will the generators also cause the meter to go to zero?)  The
multitester measures AC, DC voltages, DC current and resistance.  I hope
that one of these functions will be useful for testing the connections of
the generators before I take them apart and resolder (which I don't want to
do if I don't have to).
Thank you in advance for help!
Beth
--
Commit Random Acts of Kindness

----------


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>