In a message dated 9/14/00 10:13:16 AM EST, [email protected] writes: << Subj: Re: CS>Re: Water test for CS Date: 9/14/00 10:13:16 AM EST From: [email protected] (Robert L. Berger) Reply-to: [email protected] To: [email protected] Roger; If you are getting ARC CS without NO3 then you have some unusal setup that excludes air from the arc chamber as well as eliminating the absorbes N2 that is in the DW. I would be interested to try and duplicate your process as a 20 lb CO2 tank is rather unwieldy. I have found that there is a lower limit on CO2 flow that is needed to sweep the dissolved nitrogen that is absorbed in the DW out of the system. The air in the arc chamber is how Dr. Farber in Germany made the nitrates for their WW2 bombs. A review of chemisrty will show this fact. Somehow you have sealed air out of the system. I would like to check your CS for NO3 and PPM. I do it at no charge. "Ole Bob" >>
Bob: Thanks for the offer. I'll send you a sample of a ~ 6 gallon batch I just finished making tomorrow. How much do you need? As far as nitrate is concerned, I think we've already established that my HVAC arc process appears to operate at a significantly higher silver electrode temperature than yours because, invariably, a molten silver sphere drops off the electrode and is quenched in the water bath below. In addition, sputtering, as I refer to it, occurs when there is ADDITIONAL heat transferred into the molten silver sphere. This can be accomplished in at least two ways, adding power (which only works consistently AFTER the molten silver sphere drops off because the existing energy is concentrated onto a much smaller surface), or -- believe it or not -- reducing power because the molten sphere begins to solidify leaving the ionizing beam "hole" much smaller which concentrate the remaining energy into a much smaller surface and raises the temperature sufficiently to promote sputtering. All this explanation aside, isn't it true that the higher the process temperature the less stable are nitrogen-oxygen compounds? And if this statement is true (which I believe it is) then could my higher operating temperature be THE reason why my arc process DOES NOT produce nitrate or nitrites? Roger -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
