Hi Tim, On Thu, 14 Sep 2000 22:20:21 -0400, "Tim Eastman" <[email protected]> wrote:
>Real simple question. I just got a "WallWart" from Radio Shack which is >switchable between 15 & 30v. I don't (yet) have a meter of ANY sort to guage >current. So to start CS production on a shoe-string budget my question(s) >is/are for the following set-up > >16 oz DW (beaker type glass) >Rods >Radioshack DC 15/30v converter. > >Should I use 15v or 30v? >Since I do NOT have a meter how long should I let the process go to get good >CS? Wouldn't there be a time to current ratio? I assume you have .999 (99.9%) fine silver rods. Put them in the distilled water, making sure that only the silver touches the water. Connect the wall-wart, set at 30 volts, to the rod ends that are out of the water. After 15 minutes, switch the voltage to 15 volts. Run that for 30 minutes or so. You should have pretty good CS at 8 ppm. (You could run the batch at 30 volts for about 25 minutes total, but according to the gurus around here, the particle size would be bigger -- it should still be about 8 ppm). -- Dean -- from (almost) Duh Moyn (CDP, KB0ZDF) -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
