Hello Tom Moody; I reply to your post about constant current generation, I will answer your questions and then some!!!
> At present I use a small 9v batteriy in series with a 6v 40mA lamp and a > pair of 99.99% 2.5 mm diameter by 75 mm long silver rods. > > I think it is about 8 pH . Cloudy grey fine CS particles like a drop of > milk in water. > When I see things like this my curiosity gets the best of me, so I took 4 ounces of tap water that had been filtered with a Brita filter and setup 9 volts 1 1/2" spacing, measured the current and ran it for 5 minutes. These are the results: The initial conductivity in microSeimens (uS) was 799 uS after five minutes it was 778 uS. The current ran between 20.6 to 21.3 ma. A tyndall was evident within 30 seconds. The silver chloride started to form with in several seconds, and the whole thing turned milky. The surprise came when I checked the ppm. Believe it or not it cheched out at 39.6 PPM!!!!!! However I will leave it to the Gurus to say whether or not it is fit to drink. Personally I would not use it as I do not know what else is in the solution. The question is does it contain silver flouride as well as silver chloride???? What else is in your city water? > Also, some time ago you sent me some info for beginners. I have the > literature but lost all from my pc. Could you please send that to me > again. The MS/m is the conductance of the water in microSeimens. I need a US mail address. "Ole Bob: >
