Yo Duncan, This turning into a major project! Your enthusiasm is infectious...just when I should be studying for exams.
Impedance of distilled water : Usually measured as conductance, units microSeimens (uS) and is the inverse of impedance (units used to be called microMhos). Ohms = 1,000,000/uS The conductance is measured between 2 electrodes forming 2 opposing sides of a 1cm cube of water. Bob Berger has done a lot of measurements of different distilled waters and has reported that good distilled water measures 0.22uS but can measure up to 5.0uS. This equates to an impedance of about 4.6megOhms to 200KOhms, which as you can see is quite a range. I suggest you obtain a cheap conductivity meter, calibrated from 0.0 - 99 uS. This will also enable you to test for consistency in the brew. By the way : from http://www.ozonio.com.br/medical.htm OZONATED WATER For prevention, a major benefit can be derived from regularly drinking ozonated water. Water is a fascinating substance, and we all take it for granted. Chemically it is considered to be on oxygen atom bound with two hydrogen atoms. The bond angle beween the two hydrogen atoms is known to be variable, depending on the amount of energy in the molecule. Research has shown that water whose bond angle is 101 degees is 'dead' water, bereft of life-giving energy. When water is distilled the bond angle expands to 120 degrees upon evaporation, but collapses to 101 degrees upon condensation, and is therefore dead. A bond angle of 103 degrees corresponds to average water. A bond angle of 106 degrees produces activated, energized water, and is attainable by placing a magnet, north pole inward, against the water container. The highest energy obtainable in liquid water is a bond angle of109.5 degees, and this is attainable only ozonating water at 4 degrees C. Ozone will not stay in water for very long, even at 4 degees C. To hold the ozone in the water over long periods, it is necessary to add a few drops of Concentrace, which is a solution of trace minerals from the Great Salt Lake with the sodium, cadmium, copper and lead removed. The ozone hangs on to the minerals without oxidizing them and remains available over many months. In general, unmineralized water should not be consumed. Drink water that has gone through reverse osmosis, carbon filtering, and is then ozonated. There are some contaminants that will pass through R/O and carbon, such as fluorine. Ozonating the water removes all such contaminants and energizes the water until the bond angle reaches 109.5 degrees. Ozonate water for 15 minutes per litre, about five minutes per glass. Ivan. ----- Original Message ----- From: "Duncan Crow" <[email protected]> To: <[email protected]> Sent: Friday, 20 October 2000 18:44 Subject: Re: CS>DANGEROUS generator > Hi Ivan, Marshall, Bob, Roger, > > (BTW I actually get nearly 2 qt per 3 minutes with RO water 1.8 liters). And > it seems strong. Will test after I tinker. > > Perhaps someone knows about what kind of impedence distilled water has. I'd > like to get the on-demand or continuous-flow prototype fairly close the > first time. I have no tech. tools and I'm working on very basic > understanding, a little logic, luck and math. > > Distilled water's impedence at say room temp 22degrees celsius and per inch > or centimeter...would be at least a starting point. I'm thinking about > keeping the current travelling at least 3" through the water even with the > water flowing and I'll accomplish the rest by tinkering with the flow rate. > > Of course I'll have to check the ph with the RO water. But now I have a > local water expert helping me. He's from Eastern Europe and is also going to > sell 'living water' in addition to RO and spring water. It may have been > mentioned on this list - Living water has the hydrogen atoms separated about > 3 more degrees on the oxygen atom that processed (dead) water. It's good for > you - energizes and helps you absorb nutrients faster. That's why I > mentioned North magnetic water input into the system. Does a similar thing > to natural creek water (103-104degrees radius is optimal) > > Any help at all would be cool...(from any of you techs) > > Thanks for being easy on me after the -DANGER-HIGH VOLTAGE message from > Steve and Jackie Young. He's right of course, but with knowledge he seems to > posess you'd think he'd write more often. Thanks Steve. I could only > recommend a high-voltage system to a very careful person or a tech. I turned > down a request for a circuit diagram. If he needs one for this kind of > modification he should get someone to help him. > > ciao > > Duncan > > > > > > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: [email protected] > Silver-list archive: http://escribe.com/health/thesilverlist/index.html > List maintainer: Mike Devour <[email protected]> >
