Steve-- Thanks for your offer. Have you tried drawing it (e.g., w/paintbrush), saving it as a file name, clicking the "attach" button on your email program, and selecting that file? I've attached an example of this; click on "Show Attachments" or the like...
I've waned to go the HV route for some time for the same reasons AND smaller particle size, but not like "Ole Bob's" designs--thanks! My address is: Russ Rosser 304 Old Camp Rd. Gadsden AL 35904 BTW, here's an email about a LV current control circuit: "The LM317 circuit in the positive supply side produces good colloidal silver, with a 1200 ohm resistor between the adjust and output. You can also use the LM334 IC and a 68 ohm resistor in the output and adjust circuit for 1 ma or 34 ohms for 2 ma. However, the LM334 can't handle a lot of current so I like the LM317 for short circuit protection." In case you're interested in the Molecular Enhancer, here's my explication: Based on the premises 1) that cells must have an optimal mV potential across the membrane in order to propertly intake nutrients & secrete wastes, and 2) that parasites can feed only in a discharged environment, the "Molecular Enhancer" charges the entire body with manifold AC frequencies simultaneously (from 60 Hz to well into the MHz range, at least), ostensibly enhancing immunity & overall energy level, when used for minimum of 20 min./day (no known maximum). TO USE: plug it in, then remove the bulb from its holder with both hands, then place bare feet--one at a time--on the lower part of the glass (over the foil & away from the copper). To release, repeat the process in reverse order. Jugs of water also "structure" when placed on the glass for 20 min. or more. TO BUILD: One lead of a large neon transformer [A] is attached to an aluminum foil sheet [B], sandwiched between 2 glass plates [C & D], approx. 2.5'D X 2' W. A specially cut copper sheet [E] (note zigzag sides & square-cut corners) lies on the top glass [D], in the upper right-hand corner. Note tab on right-hand side of the copper sheet, bent upward. A fairly thick piece of plexiglass [F] lies over the copper sheet (the inventor routs a concave shape into it--probably by heating & melting the copper into the plexiglass--which helps to position the copper sheet). The copper tab extends upward through a slot in the plexiglass, and is attached to leads from the other side of the transformer and the neon bulb [G]. (The whole thing is mounted on thick plywood, not shown.) --Russ On Sat, 2 Dec 2000 22:40:58 -0700 "Steve & Jackie Young" <[email protected]> writes: > Hi do-it-yourselfers, -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
