Sorry, I meant conductivity increases, not decreases.

Marshall

Ivan Anderson wrote:

> But what about the conductivity increase caused by the silver ions?
>
> Ivan.
>
> > -----Original Message-----
> > From: Marshall Dudley [mailto:[email protected]]
> > Sent: Saturday, 4 August 2001 02:07
> > To: *Silver-List*
> > Subject: Re: CS>Where to find 50 ppm......
> >
> >
> > Maybe we should try putting some silver in H2O2 after measuring
> > the conductivity
> > of the H2O2.  If the conductivity drops then it is likely that
> > the silver did
> > end up in the H2O2 (or even better test the result for H2O2 with
> > spectrophotometery or other means).
> >
> > Marshall
> >
> > Ivan Anderson wrote:
> >
> > > Frank,
> > >
> > > I do not know what is causing the metallic silver to dissolve,
> > but dissolve
> > > it does, conforming no doubt to the law of physics.
> > >
> > > I am still not convinced that metallic silver does not dissolve to some
> > > degree in water, even if you laugh at such a silly idea!
> > >
> > > >From www.silverlon.com
> > > note: silverlon coating is 99% metallic and 1% oxide.
> > >
> > > Differences in the Release Rates of Ionic and Nonionic Silver
> > >
> > >  The silver released from the Silverlon® surface is 100% in the
> > ionic (Ag+1)
> > > with no silver released in the metallic nanocrystaline form.  The silver
> > > released from the Acticoat® surface is ionic (Ag+1) and metal
> > > nanocrystaline.  The vapor deposition technique utilized in the
> > manufacturer
> > > of Acticoat® creates nanocrystaline clusters on the surface of
> > the plated
> > > surface that are easily displaced by mechanical forces.
> > Quantification of
> > > the rate of silver (nanocrystaline and ionic) release has been
> > measured for
> > > Silverlon® and Acticoat® in vitro.  The Silverlon® silver
> > release rate was
> > > measured in vitro in a specified volume of tryptic soy broth while the
> > > Acticoat® silver release rate was measured in water flowing through the
> > > Acticoat dressing at a flow rate of 0.33 ml/hour (considered
> > ultra slow) or
> > > 7.92 ml per 24 hours.  In 24 hours, Acticoat® (64 cm2) release 40
> > > microgram/ml of water.  In 24 hours, Silverlon® (100 cm2) Wound Contact
> > > Dressing released 30 micrograms/ml of tryptic soy broth.
> > Tryptic soy broth
> > > more closely approximated the physiology of a wound than water.
> >  Due to the
> > > differing experimental procedures, conclusions are difficult at
> > best.  The
> > > silver released from Acticoat® comprised a mix of ionic silver and
> > > nanocrystaline species of silver whereas the silver release
> > from Silverlon®
> > > comprised only ionic silver.
> > >
> > > > -----Original Message-----
> > > > From: Frank Key [mailto:[email protected]]
> > > > Sent: Friday, 3 August 2001 00:00
> > > > To: *Silver-List*
> > > > Subject: Re: CS>Where to find 50 ppm......
> > > >
> > > >
> > > > Ivan wrote:
> > > >
> > > > > If the silver is absorbed as you believe, then no reaction
> > would occur
> > > > > between the host and the silver, or the silver and any
> > > > pathogens. However,
> > > > > it has been determined that silver coated bandages (silverlon)
> > > > provide an
> > > > > influx of silver ions into the wound, when the bandage is kept
> > > > moist, so the
> > > > > silver metal obviously dissolves in these conditions.
> > > >
> > > > So what exactly is causing metallic silver to dissolve?
> > > >
> > > > The last time the discussion of silver dissolving was raised, you
> > > > claimed silver dissolves in water.
> > > >
> > > > frank key
> > > >
> > > >
> > > > --
> > > > The silver-list is a moderated forum for discussion of
> > colloidal silver.
> > > >
> > > > To join or quit silver-list or silver-digest send an e-mail
> > message to:
> > > > [email protected]  -or-  [email protected]
> > > > with the word subscribe or unsubscribe in the SUBJECT line.
> > > >
> > > > To post, address your message to: [email protected]
> > > > Silver-list archive:
> http://escribe.com/health/thesilverlist/index.html
> > > List maintainer: Mike Devour <[email protected]>
> > >