I surmise that the hydrogen bubbles are forming so slowly at first that they don't grow to sufficient size and bouyancy to overcome their adhesion to the electrode before becoming covered with colloidal silver particles. These particles form a shell around the bubbles further reinforcing thier structure and preventing bubble growth.
If this condition is allowed to continue throughout the process, the semiconductive properties of the bubble/silver shell structure may prevent the generator from shutting itself down in a timely manner and the white spot and grey stuff may grow and grow.
This is what I call a feedback cycle or loop.
The cause is probably very pure water that starts the CS process extremely slowly, forming very small sticky bubbles at first.
The solution:
Increase initial conductivity by heating the water and/or seeding. Wipe the rods off whenever a fuzzy deposit starts to form. Usually, this only need to be done once within the first half hour as it breaks the feedback loop before it gets well started. By then, the water has gained enough conductivity to allow larger, more bouyant bubbles to form.
Use a small central heat source on the bottom of the container to promote more vigerous thermal stirring. A heating pad or shining a desk lamp on one side of the container will do but the heater lamp on the website is sooo cool to look at and works like a charm.
Notice that if you unplug the generator and let it sit, the fuzzy grey stuff will produce a white cloud in the water just like the initial "ion" cloud until all the hydrogen bubbles have dissappeared. That which doesn't disburse is what makes the white deposit. It is basically a pure silver powder.
All this stuff can be strained out and doesn't really harm the batch.
Ken
At 10:51 AM 8/10/01 EDT, you wrote:
>>>>
I have been making CS for about two years, the past year using a silverpuppy<<<<
generator, which I find eminently satisfactory. During the last couple of
months, however, a thread of material hangs on to the leg that has the
bubbles. When I remove the generator the thread falls to the bottom of the
glass. It ends up as a small, but quite noticeable amount of white powder on
the bottom of the glass. I use only steam-distilled water which I make myself
and the glass is cleaned in a dishwasher.
Anybody have an idea what is happening here and what the powder might be?
Allen
-- The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>

