Dear Allan D, A friend of mine in Western New York wants to start up CS production in the way that your post has indicated. I would appreciate it if you could tell me how he will be able to distinguish his CS from ordinary water at the end of the five hours. Is there a Tyndall effect? Can he use an ordinary flashlight as opposed to a laser pen in order to see this. He's quite ready to start up on a low cost basis. Also, are there particular brands of water to look for?
Many thanks for sharing this information! Reid Harvey Allan D Kruest Sr. wrote: This post is for information to the list and not intended to ignite a fire of controversy..Allan D. These are excerps from Dr. Jon Brooks.. Note: The following was taken from the research of The Alternative Medicine Research Foundation, a non profit Charitable Trust. His newsletter can be gotten at this site ------------------------------------------------- [email protected]. This is a partial excerp and the full letter is on the site or it's links. EVEN DUMMIES CAN MAKE HIGH QUALITY CS This ain't rocket science so pay attention. Don't email for more information. I haven't the time for hand holding! 1. Buy a 6 volt DC transformer for about 5 clams. Better yet, pick up one at a flea market for .50. The current doesn't matter as this method uses less than one ma. 2. Clip the connector off the end of the wire. 3. Get two alligator clips from Radio Shack for a buck. 4. Carefully separate the two wires. Strip the insulation off for about 1 inch. 5. Connect each lead to the clip. 6. You need two electrodes. Don't waste $15.00 for 1/4 oz. pieces of silver wire. Go to a any coin store and buy two Canadian Maple Leafs for about $6.50 ea. Each has 1.2 oz. of .9999 pure silver, enough to make more CS than you will ever use. 7. Buy a gallon of distilled water for about .70. 8. Buy a tiny fish tank bubbler machine for about 8 bucks. They will have the neoprene tubing as well. You will need about two feet. 9. Be sure the coin is squeaky clean. Clamp them to opposite sides of an 8 oz. glass of distilled water. 10. Place the tubing to the bottom of the glass. 11. Fill the glass with distilled water ONLY up to the bottom of the clips. One does not want the metal, from the clips, in contact with the water, only the coins. 12. Plug in the little transformer and oxygenation machine. 13. Run for about five hours. 14. Carefully remove the coins. There will be residue on them and you don't want that in the solution. For even more purity, use the neoprene tubing and siphon the solution into a clean glass/or plastic container. (In these parts a siphon hose is referred to as an "Arkansas credit card".) 15. Keep the CS out of sunlight in an air tight bottle. 16. Clean the coins thoroughly preparing for the next batch. Now you have high quality CS in about 5 PPM. Some scoundrels claim their CS is 100-800 PPM. This is rubbish. At such concentrations the particles would agglomerate forming much larger particles. Basic chemistry. -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
