Ole Bob gives his regards to the list once again. He mentioned something about re-subbing in the near future.
So, he made the top for my 4 gallon brew tank. He uses a 12K 60ma neon sign transformer which was used to run the first test batch for 5 hours. 9.9ppm with virtually no TE. My transformer is a 15K 30ma....so we decided to take samples during the first brew with it, samples taken at 2, 4, 6, 8 and 10 hours. Of course, I stirred it up well before grabbing my sample.... Results were so inconsistent that Bob suspects 1. big differences using 15k/30, 2. stirring between samples caused the results. An example, the final batch after 10 hours (which was stirred every 2 hours) was 8.6ppm. Yet, a batch made for 6 hours without stirring yielded 16.7ppm. Go figure. So, needless to say, this intrigued Bob to such a degree he now gonna test this out, stirring every hour and plot and see what the real deal is. He has never stirred a batch using the HVAC Arc method until the very end, which, if one is watching closely, it is a mesmerizing site watching stratified water mix. Funny, during the testing on the first sample, he mumbled "hmmm, I'm a little concerned you have nothing here" and I tell ya I felt like a school kid failing a test that I thought I did good on. Happy Brewing... Rich Adams -- The silver-list is a moderated forum for discussion of colloidal silver. Instructions for unsubscribing may be found at: http://silverlist.org To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
