An auto spark coil would be problematic.  First it would be difficult to
get the current you need, since they step the voltage up by over 1,000:1
I believe.  It would require an amp to generate a milliamp of current on
the secondary.  Second, the coil is made to operate at high frequencies
(that is a rapid rise and fall time).  To allow the silver time to
aggregate into particles, or move sufficiently away from the electrode
before reversal (and it will reverse, even if the waveform is
asymetrical unless you put a high voltage diode in the secondary) would
require very high voltage.

Lets take an example.  To make a gallon an hour at 60 htz requires abou
10K volts and about 25 mA of current.  With a spark coil, which
typically has a 10 microsecond pulse before the leakage inductance
shorts it out, it would require 50,000 pulses a second to maintain the
same duty cycle.  But this would quickly burn the coil out, since it is
made for duty cycles of maybe 1/100 of that max.  So if we run it at 500
pulses per second, we are running at about 1% duty cycle.  The amount of
current necessary would need to be about 100 times large for the same
production rate.  Thus we need about 1.4 Amps of secondary current. With
the step up these have, that would require about 3,000 amps on the
input.  And since the frequency is about 8 times as high, the current
needs to be about 8 times as high as well, or about 30,000 amps.  Of
course if you want to make it at a slower rate, then you could use a
lower amperage, of maybe 1 amp, and make a gallon in about 30,000 hours.

Now I could be off by a factor of 2, or even an order of magnitude on
some of these estimates, but the result would still be the same. I
believe it would be impratical.

Use a 15 KV neon sign transformer like I do, and it will work fine.

Marshall

[email protected] wrote:

> Has anyone tried making a HVAC generator for CS with a 555 timer and
> an auto coil? If the waveform is symmetrical and there is no ground
> reference then pulsed DC should work just as well as AC. Just
> curious...
>
> Andy