I've got a few emails out for quantity pricing (500, 1000 and 5000 lots),
and I'm going to call Motorola tomorrow (they make it and they're local), so
I may be able to get a pretty good price on them.  I'll let everybody know.

Yours in health,
James Allison



----- Original Message -----
From: "~Ron N" <[email protected]>
To: <[email protected]>
Sent: Sunday, December 29, 2002 5:45 AM
Subject: Re: CS>Simple Current Limiting CS Generator


> American Microsemiconductor, Inc.
> 133 Kings Road, Madison, NJ 07940 USA
> Tel: (973) 377-9566
> Fax: (973) 377-3078
> [email protected]
>
> http://shop.store.yahoo.com/americanmicrosemiconductor/info.html
>
> This company has the 1N5295 (.82 ma) in stock for $3.16 ea. Although they
> have a $35.00 min.
>
> Also ya might want to look into using the LM334Z IC (variable) with a pot
or
> 100 ohm resistor.
>
> ~Ron
>
> ----- Original Message -----
> From: "S & J Young" <[email protected]>
> To: "Silver List" <[email protected]>
> Sent: Saturday, December 28, 2002 7:01 PM
> Subject: CS>Simple Current Limiting CS Generator
>
>
> >
> > Fellow CS brewers,
> >
> > Not well known is the fact that for about $5 you can easily convert your
> > constant voltage CS generator (e.g. a three nine-volt battery setup) to
> one
> > that limits the current to assure small particle production and prevent
> > current "run-away".  Thus your unit would then function the same as the
> > better "constant current" commercial units.  I will try to describe this
> in
> > non-technical terms so many can take advantage of this.
> >
> > There is a device called a silicon FET current regulator diode that does
> the
> > trick.  This is really a small integrated circuit, shaped like a small
> > rectifier diode, that limits current flow to a set value.  The regulator
> > diodes are small cylinders with about a 1 inch wire coming out of each
end
> > of the cylinder.  One end of the cylinder is marked with a band around
it.
> >
> > The part numbers are the series 1N5283 through 1N5314, with the current
> > limits in the range of 0.22 ma thru 4.7 ma, respectively.  Probably the
> one
> > of most interest to us is the 1N5297 that limits the current to 1.0 ma.
> One
> > manufacturer is Central Semiconductor Corp.  Go to www.centralsemi.com
and
> > search for 1N5297 if you want to see the specifications and a drawing of
> the
> > device.
> >
> > Using them is super simple.  For example, for a three nine-volt battery
> > system, just cut the wire between the minus terminal of the battery and
> the
> > silver electrode.  Connect the wire from the battery minus-terminal to
the
> > "banded" regulator diode wire.  Connect the wire from the silver
electrode
> > to the other "non-banded" regulator diode wire.  One can use 2 small
wire
> > nuts, available at any hardware store, to make the connections,
alligator
> > clips, or solder and tape them.  Congratulations - you now have a
> > sophisticated constant current CS generator!
> >
> > When brewing a new batch, the current will start out very small as
> before --
> > a few microamps--depending on water purity.  As silver production
> proceeds,
> > the current will rise until it reaches the value set into the regulator
> > diode.  Then it will stay constant (e.g. at 1.0 ma for a 1N5297) for the
> > remainder of the brew time.  It is impossible for the current to "run
> away"
> > and increase beyond the "set point", even if the electrodes accidently
> short
> > together.
> >
> > These regulator diodes are rated to a maximum of 100 volts.  That means
> one
> > could use a higher starting voltage (e.g. 54 volts from six nine-volt
> > batteries) and reduce the brew time (it will take less time for the
> current
> > to reach 1.0 ma).  Again, the higher voltage is perfectly safe as the
> > current cannot "run away" because of the current limiting effect of the
> > regulator diode.
> >
> > These devices are not widely used so they are not available from many
> > sources such as Radio Shack.  One source that sells them is Mouser
> > Electronics.  Go to www.mouser.com and search for the part # 1N5297 and
> you
> > will see the information.  When I checked recently, they had about 1,500
> of
> > them in stock for a price of $4.29 each.  I suppose they have a minimum
> > order, so it would be a good idea for someone to volunteer to order a
> batch
> > of them for those that express an interest in a group buy.  (I don't
have
> > time to do this - sorry).
> >
> > I believe the use of a 1N5297 along with a few nine-volt batteries is by
> far
> > simplest, goof-proof way to make a constant current CS generator.  If
you
> > give it a try, please let us know how your results.
> >
> > --Steve Young
> >
> >
> >
> >
> >
> > --
> > The silver-list is a moderated forum for discussion of colloidal silver.
> >
> > Instructions for unsubscribing may be found at: http://silverlist.org
> >
> > To post, address your message to: [email protected]
> >
> > Silver-list archive: http://escribe.com/health/thesilverlist/index.html
> >
> > List maintainer: Mike Devour <[email protected]>
> >
> >
> >
>
>