To make a good clean stirrer:
Wrap a silver electrode around a 1/8 diameter rod like a corkscrew, with
a 1/4 pitch.
make it about 3/4 of the summered length of your electrodes in length.
Sharpen the lower end of the corkscrew horizontally to provide a smooth
action when the tip enters the water, during operation.
Then wrap it tightly about one inch around a #14 house wire, now cut the
insulation and remove the wire, not the insulation. This end becomes the
coupling to the motor.
Use Ole Bob little dude motor with his recommended resistors.
Regards
Peter R
--
The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
