Have you hear of "cupping" to draw the boils to a head?
Smear area with oil
Place a small piece of alchohol soaked tissue paper in a small bottle,
tumbler or shot glass. [even a plastic asprin bottle..anything with an
opening that will cover the boil and has some air capacity behind it]
Light the alchohol and snuff it out against the boil. [the fire goes out
so fast it doesn't hurt or burn anything]
Draws a pretty good vacuum that pulls everything to the surface and
sucks everything out.
Then get pair of tweezers and go after the pus sack.
If you don't get the sac out, it will either be assimilated or grow
through the healed skin for a long time. If the boil is killed before the
pus is drained and it heals up, there will be a lot of dryed up white stuff
under the skin in a cystlike structure that will probably grow outwards for
a long time and eventually pop out like a chaulky marble.
You might even use a syringe without a needle to inject the hole with CS to
prevent reinfection.
Ken
At 10:52 PM 3/15/2003 -0500, you wrote:
Hi Harvey,
Topical treatment of boils sounds like a good candidate for CS mixed with
DMSO. Perhaps someone more knowledgeable then myself can tell you what
proportions to mix them.
Good luck,
Andy
From: Harvey Norris
My freind who has boils on his back is now drinking
the 1.2 ma DC current limited CS daily. It sure is a
relief not to have to clean the coins every hour or
so, which was occuring with the 1.5 ma, and 2.3 ma
versions. It takes quite a long time period to obtain
a quadrupling of initial battery test amperage from a
~ 20 volt DC battery test. It takes at least 10 hours
or so at 1.2 ma current limited amperage, with a final
20 minute run from the battery source to get the
conductivity up to the quadruple point. ( 4.8 ma- 5.2
ma final test) My freind still has these terrible
boils.
I was reading the Bob Becker discovered things about
silver from a topical treatment on wounds. Should we
have to worry about Nitrous oxides for a exterior
treatment for boils? I made my freind a batch of the
higher DC voltage stuff,( not for drinking but for
skin application) that looks pretty nasty, a dark
grayish brown solution on the second day of treating
it. This batch was current limited to 15 ma, and has
larger particulates, and a gritty residue on the
bottom of the glass after pouring to container. This
left a unfamiliar white tarnish on one of the coins.
The conductivity appeared to go up and down when
making it, with a final reading of about 8 times the
original conductivity. Any objections to larger
colloid CS for topical treatment, or should we merely
use fine colloids as made for drinking for topical use
also? We wanted a higher concentration of silver
particles for the topical use.
HDN
--
The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
