I don't know what they used as a benchmark, all they say is "Our testers
are calibrated specifically for colloidal silver".
Go to: http://www.utopiasilver.com/accessories.htm and scroll down to
the TDS1 tester for more info.
Jim
Ode Coyote wrote:
It would be interesting to know what was used as a benchmark.
Apparently, some benches are of different heights and some look more
like counters.
I would trust a benchmark based on electrical conductivity of a known
[solid?] substance rather than some dubious liquid solution.
Typically a PPM meter will read half that of a microsiemens meter such
as the PWT.
Ode
At 06:21 AM 6/7/2003 -0500, you wrote:
My TDS -1 reads from 0 to 999 not 0 to 2000 and it is calibrated to
measure homemade CS.
Jim
The TDS-1 from Hanna Instruments is a good bit cheaper, but it reads
from 0 to 2000 ppm. You'll be using it at the *very* bottom of its
range, which means the accuracy will not be tremendous. Sorta like
measuring grains of sand with a yardstick. Do you see what I mean?
--
The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
