Have u tried a nebulizer with CS for ur mold problem?
At 11:55 PM 9/21/2003 -0400, you wrote:
url: http://escribe.com/health/thesilverlist/m62645.html CS>cs and cancer Trem From: Trem Date: Sun, 21 Sep 2003 12:50:29 Hi Trem, > Hi Mike, > Thanks for your comments and the link. I hadn't seen any > references to viruses and cancer but it was a no brainer for me > after seeing these cancers disappear. I just couldn't deny what I > was seeing. I knew that they couldn't all be spontaneous remission > and CS was the only thing they were taking. The information I collected describes more varieties of cancer and the different types of viruses that cause them. Also, most of the population carries some of these viruses around, ready to strike whenever the immune system degrades. Your news is exceptional. It is the first time I have heard of cs killing cancer. But it makes sense. > One of my favorite sayings is "I want to save the world...10 to 20 > PPM at a time." I think it's working. I think so too. After seeing the effect that high ionic cs had on my Shingles virus, there is no doubt in my mind that you are killing the cancer. This is amazing news, Trem. Thank you very much for posting the information. But the cs has to be strong - 20 ppm or more. The 10 ppm or so from the 3 nines won't do the job. At least, it didn't help my Shingles problem one bit. > The PWT meters usually read 20+ - 25 uS at completion of the test > run but that figure drops down overnight as some of the ions > change to colloids. I wasn't sure how you converted from uS to ppm - it looks like you use a unity conversion factor. I found some interesting data on Frank Key's site that may help validate this. He measured the uS and ppm for a number of products and lists the results at: http://www.silver-colloids.com/Reports/reports.html I selected five that seem to correlate well. Here is the list: Product Name Conductivity Ionic PPM Ratio ~~~~~~~~~~~~ ~~~~~~~~~~~~ ~~~~~~~~~ ~~~~~ Silver Lightning 3.3 uS/cm 3.71 ppm 0.889 Mesosilver 3.9 uS/cm 3.9 ppm 1.0 Sovereign Silver 9.7 uS/cm 9.22 ppm 1.052 ASAP Solution 11.4 uS/cm 10.65 ppm 1.070 ASAP Solution 20.1 uS/cm 19.59 ppm 1.026 The average is 0.889 + 1.0 + 1.052 + 1.070 + 1.026 = 5.037 / 5 = 1.0074 So it looks like the unity conversion factor is valid. I'm sure you know about adding a bit of H2O2 to convert those useless oxide particles back to good ions. Please forgive me, but I just gotta insert one equation here:) I think the H2O2 acts as a catalyst to convert silver oxide to ions: 2Ag2O + H2O2 --> 4Ag(+) + O2(g) + H2O2 So the H2O2 is not consumed and will continue converting the oxide as soon as it forms. Probably the H2O2 will degrade with time, but the cs should have been ingested long before that happens. I don't think the stabilizers they add are any problem at such low concentration. When I push Godzilla to over 30 ppm (calculated), it starts showing a slight tint. When I add about 0.2 ppm of H2O2 (1/2 teaspoon per litre) and let it sit overnight, the tint disappears. The amount of H2O2 is so small it is barely noticeable. > Regards, > Trem > P.S. Have you found a new apartment or are you still struggling > with mold spores. I hope you're feeling better and get well soon. Thanks for mentioning it, Trem. It looks like the battle is over. The mold has won, and I'm out of resources to continue the fight. Best Regards, Mike Monett -- The silver-list is a moderated forum for discussion of colloidal silver. Instructions for unsubscribing may be found at: http://silverlist.org To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
