Go to Mouser Electronics on Net 
You can get a current regulator/limiter diode 
They range from 0.22 Mill Amp to 4.70 MA  (1 MA works good)
Solder it in right direction on plus side, with marking bar as out to clip
on Silver.
I found that these Diode Regulators are different than a plain Diode as they
passed current in both
Directions but the wrong way was less than the Rating.
If you really want to get Cheap look a little above or below 1MA they are
Cheaper
The 1 MA will adjust DC Voltage to let no more than rating pass
You can read voltage and adjust silver distance apart and watch voltage
change but you will never
Pass more than 1 MA (if you use the 1 MA) 
They are good up to 100 volts
The 1 MA is around $5
Part Number is 1N5297  for 1 MA other sizes are there
You can make CS with 3 volts DC just move silver close as you are limited on
current flow
For larger Silver Electrodes you can use Higher MA unit
See list archives for current and electrode size
You can use any DC supply you have around house or buy something cheap
For less than $10 you have a Constant Current Regulated CS Generator
Bob

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Julius Kabrun
Sent: Thursday, March 11, 2004 12:37 AM
To: [email protected]
Subject: CS>Fw: Fw:Re: CS> 10A 6.8V



----- Original Message -----
From: "Julius Kabrun" <[email protected]>
To: <[email protected]>
Cc: "Bil Green" <[email protected]>; <[email protected]>
Sent: Wednesday, March 10, 2004 10:27 AM
Subject: Fw:Re: CS> 10A 6.8V


>
> ----- Original Message -----
> From: "Julius Kabrun" <[email protected]>
> To: <[email protected]>
> Sent: Tuesday, March 09, 2004 11:30 PM
> Subject: 10A 6.8V
>
>
> > Hi y'all,
> >
> > Wanted to use my CS maker today after a year .   Works on 3 x 9v but
today
> > it was obviously defunct.  No sign of life.
> >
> > Then bethought myself of some transformers I bought foolishly about 
> > 10
> years
> > ago as part of a silver reclamation from photographic hypo project .
> Never
> > worked . Total waste but tried to put them into action tonight.  
> > After making some fuses with thin strips of aluminum foil two worked 
> > .
> >
> > After being on for 4 hours the current measured 10 amps  on the 
> > meter on
> the
> > transformer  & the current 6.8v at the 2  wide anode/cathodes which 
> > have both blackened.
> >
> > Anybody advise me as to what is happening???   Is this producing CS???
> > Where can I get a ppm CS meter.???
> >
> > Best Regards,
> > Julius Kabrun.
> >
>


--
The Silver List is a moderated forum for discussing Colloidal Silver.

Instructions for unsubscribing are posted at: http://silverlist.org

To post, address your message to: [email protected]
Silver List archive: http://escribe.com/health/thesilverlist/index.html

Address Off-Topic messages to: [email protected] OT Archive:
http://escribe.com/health/silverofftopiclist/index.html

List maintainer: Mike Devour <[email protected]>