Hi: I too am new to the list and will find time soon to introduce myself. I also had the conductivity problem but found that if the distilled water was less than 3ppm I set my rods 3/8 inch apart and run 30 DC volts for 5 minutes to get some particles of silver in the water. I then set them 1-1/4 inches apart to finish the brew. I found this to work well until I went to the high voltage process, which I use now.
Bill Amos -------------------------------------------------------------- Hello everyone! I am new to this list and I have a question. I have been searching for a CS system and was looking at CS Pro. http://www.csprosystems.com/UniPhaseMaxPg.html . They mention that they use Baking soda to control PH and conductivity of the water. I know salts are bad to add from the research I have done on the net, but will baking soda hurt anything? Any other suggestions for a high capacity unit? Thanks in advance! David -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Silver List archive: http://escribe.com/health/thesilverlist/index.html Address Off-Topic messages to: [email protected] OT Archive: http://escribe.com/health/silverofftopiclist/index.html List maintainer: Mike Devour <[email protected]>
