Are you assuming that every CS generator produces an exact and reproducible ratio of CS to ionic silver? Seems like they would have to for the following to be correct.
-----Original Message----- From: Dan Nave [mailto:[email protected]] Sent: Friday, October 29, 2004 11:36 AM To: [email protected] Subject: CS>Salt test for determining Ionic Silver Concentration To use the Salt test for determining Ionic Silver Concentration: Take a known volume of EIS (Electrically Isolated Silver) and add enough salt to it so that all the ionic silver combines to form AgCl. Since AgCl has a .8 ppm solubility, you should get a precipitate. Add distilled water (at an appropriate rate while stirring) until all the AgCl is dissolved. The total volume of water in units, compared to the original amount of EIS (one unit) should indicate the ionic silver concentration. Thus, a 20 ppm ionic silver solution should require a total of 25 units of water to dissolve the AgCl produced by the addition of salt to the original solution. (That is, 20/.8 = 25). Dan Re: CS> Diet for dogs and humans From: Marshall Dudley wrote: Date: Fri, 29 Oct 2004 08:59:20 ---------------------------------------------------------------------------- ---- "Dr. David W. Kenney" wrote: > > Just make a solution of salt and water...and pour it into a sample of your > CS...if there is lots of ionic silver...you will get a white precipitate Yes, fully expected since AgCl only has about a .8 ppm solubility. But add sufficient warm water and it will redissolve slowly. Add low pH HCl and you will find that the solubility goes way up. Marshall -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Silver List archive: http://escribe.com/health/thesilverlist/index.html Address Off-Topic messages to: [email protected] OT Archive: http://escribe.com/health/silverofftopiclist/index.html List maintainer: Mike Devour <[email protected]>
