Thanks it's been 26 hours and the light is still on. Should I through it out? I just took a peak and the silver rods are tarnished with black (like silver tarnish) and when I shook them it feel of and was making it's way to the bottom. Also there are two tarnish lines run down the jar. From the bottom of the rod to the bottom. any thoughts, please worried cook ----- Original Message ----- From: kent To: [email protected] Sent: Friday, May 06, 2005 3:42 PM Subject: **SPAM: RE: CS>first batch
I have a colloid master as well. My usual setting is 6 to 6.5. The PPM tester is anywhere between 14 to 20. Which I understand correctly from the list is doubled to come up with the correct the PPM. It should be clear/slightly yellow at the end of the brewing cycle. It can take a bit of time. I do not let mine sit for 36 hours before I use it. I also do not filter it. Not sure if this causes any problems but I haven't turned gray yet Kent -----Original Message----- From: SCD Traveler [mailto:[email protected]] Sent: Friday, May 06, 2005 7:23 AM To: [email protected] Subject: CS>first batch Well I started my first batch yesterday at 4 PM. It's now 7 AM and it's not done. I have a colloid master and when I did the test for water purity it was just fine (Arrowhead distilled) So I'm not sure what to do now. I'm concerned. I did want a higher PPM so it's set on 6. I'm concerned about the keep in the dark thing." Why would that make a difference. Can I lift the box and look at it or would that ruin the batch and what about taking the box off to remove the silver and let set for 36 hours. It's seems more difficult that I thought it would be because of the darkness thing. I seen a post here about fuzz does' that stop the process and what about lifting the box to see if I have fuzz. thanks for any input worried cook
