Evening Maza,
>> I honestly am not sure if I can join these things without a
meltdown. of this little black box. Any soldering tips?
The proper wattage soldering iron, the right tip, and the proper
gage solder is the first step.
After that, practice good mechanics and watch for dirty or corroded
parts. Cleaning them a bit can help. Enameled wire is very
ornery. You have to fan the small strands out and lightly scrape
them with a knife to remove the enamel.
Finally, ......... practice is what it takes. Understanding heat
transfer will become easier and make your soldering better.
Don't give up.
By the way, the smallest thing I ever soldered was a very fine wire
in a hearing aid.
I used a hot straight pin for the soldering iron. Never did figure
the wattage on that one.
Wayne
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
