Morning Charles,
>> At 08:41 AM 2/20/2007, you wrote:
You could build one of my Telephone Line Generator, ( works at 50, 52, of
54 VDC ) and never have to buy a battery again.
Any details on this? Sounds very interesting...
It is interesting due to the low cost, simplicity, and the excellent
job that it does.
In addition, where can you go that there is not a phone outlet?
A primitive location or the jungle?
Once I had a meeting to teach friends how to make CS. Most had been using
CS and they had interesting testimonials.
I installed a phone jack on my briefcase using batteries to provide the
voltage.
Here is a pictorial that shows how to connect the
parts. http://www.fugitt.com/ph_gen.jpg
After all, there are a total of 3 parts inside.
1 resistor
1 LED
1 Small Full Wave Bridge
Cost is usually $5.00 to $6.00.
Before I built this unit, I had been using the 3 each 9 volt battery which
gave only 27 VDC. I liked the increase in speed of the 50+ volts.
I have given away a number of parts packages. One guy could not assemble
the unit so I made that pictorial and sent it to him.
It prints half decent. I can make better drawings.
Here are a few pictures of the unit.
http://www.fugitt.com/files/
Scroll down until you see a folder phonegen.
This is nothing fancy but it works and is small and compact. It will fit
in the shirt pocket.
It would be very easy to use most any power supply with this unit,
or........ series a number of batteries. By building it in the surface
phone line terminal block, a conventional phone patch cord will plug right
into the unit.
Wayne
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: silver-list@eskimo.com
Address Off-Topic messages to: silver-off-topic-l...@eskimo.com
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <mdev...@eskimo.com>
