On 01/08/2012 05:00 AM, Sergey Oboguev wrote:
If you compile it, rather than using pre-built binary, can you compile in debug mode, run under gdb and see the stack at fault point, and also the fault location?
See my reply to David.
Similarly, can you verify if SHOW XQ ETH works or also faults? _____
Show XQ ETH works. This is the (edited) output from putting a SHOW XQ ETH in front of the attach command, with all the early stuff cut out.
<paste> do> set xq mac=08-00-2B-AA-BB-CC do> show xq eth ETH devices: 0 eth0 (No description available) 1 wlan0 (No description available) 2 virbr0 (No description available) do> attach xq eth0 Segmentation fault BTW, both SIMH and libpcap were compiled from sources. Brian. _______________________________________________ Simh mailing list [email protected] http://mailman.trailing-edge.com/mailman/listinfo/simh
