> On Feb 15, 2016, at 10:19 AM, Wilm Boerhout <[email protected]> wrote:
>
> Paul Koning schreef op 15-2-2016 om 16:15:
>
> [snip]
>>> There are three parts to a successful setup:
>>>
>>> 1. Since each Pi has only one Ethernet interface, make sure you use a
>>> wired connection (wireless isn't real Ethernet)
>>>
>> Well, Wireless is 802.11 which indeed isn't 802.3 / Ethernet. But that's
>> not really relevant. The question is whether it uses Ethernet addressing
>> and offers an Ethernet-compatible MAC layer API, and 802.11 certainly does.
>> You can run SimH Ethernet just fine over a wireless LAN. I've run PDP11
>> SimH that way with no problems.
>>
>> paul
>>
>>
>>
> Maybe it is my poor choice of wireless networking adapter, or a Raspbian
> thing, but I never managed to get tun/tap networking with a bridge to work on
> the Raspbian wlan0 device (in this case, an Edimax wireless adapter), whereas
> on the eth0 device (the built in Raspberry adapter) it works instantly.
I'll have to give it a try. Well, on a Beaglebone Black, that is (I don't like
closed hardware, or hardware that tries to be open but that uses a closed chip
at the center).
paul
_______________________________________________
Simh mailing list
[email protected]
http://mailman.trailing-edge.com/mailman/listinfo/simh
