I am participating in the UUCP project and have set up a SIMH vax750 on a Raspberry Pi. I am using the 4.3BSD bits that the UUCP project lead (Warren) provides to install the system and followed his instructions for configuring it.
It uses a simulated hard-wired serial connection to communicate with a remote simulated host over TCP/IP. However, I have not been able to make this connection work. Everything seems good on the simulated VAX. But when I initiate connections to the remote host, I see no corresponding activity on my network.
Any suggestions of specific things to check to figure out why nothing is going out to the network?
alan _______________________________________________ Simh mailing list [email protected] http://mailman.trailing-edge.com/mailman/listinfo/simh
