Re: [Sip-implementors] uri parameters in request uri

Thu, 02 Feb 2006 08:24:29 -0800


The paramters should be placed in request URI as they are recieved in contact. Sone UAS may be using these parameters on purpose.


regards
Rayees


[EMAIL PROTECTED] wrote: -----

To: [email protected]
From: Sigrid Thijs <[EMAIL PROTECTED]>
Sent by: [EMAIL PROTECTED]
Date: 02/01/2006 03:22PM
Subject: [Sip-implementors] uri parameters in request uri

Hi,

I was wondering what should be done in the following case:
when a UAC receives a 200 OK to an INVITE request with no Record-Route
header, and a Contact header like this:


According to RFC 3261 (section 12.2.1.1), the UAC must place the remote
target URI into the Request-URI if the route set is empty.

Is it allowed to send an ACK with a Request-URI like this:
"ACK sip:[EMAIL PROTECTED]:5060;transport=UDP SIP/2.0"

or should the URI parameters of the Contact header be ignored?

Kind regards,
Sigrid Thijs
_______________________________________________
Sip-implementors mailing list
[email protected]
https://lists.cs.columbia.edu/cucslists/listinfo/sip-implementors


*****FSS-Private *****" DISCLAIMER: This message is proprietary to Flextronics Software Systems Limited (FSS) and is intended solely for the use of the individual to whom it is addressed. It may contain privileged or confidential information and should not be circulated or used for any purpose other than for what it is intended. If you have received this message in error, please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly prohibited from using, copying, altering, or disclosing the contents of this message. FSS accepts no responsibility for loss or damage arising from the use of the information transmitted by this email including damage from virus."
_______________________________________________
Sip-implementors mailing list
[email protected]
https://lists.cs.columbia.edu/cucslists/listinfo/sip-implementors

Reply via email to