Hi all
Below is an excerpt from RFC5626;
" The sequence of reg-id values does not have to be sequential but MUST
be exactly the same sequence of reg-id values each time the UA
instance power cycles or reboots, so that the reg-id values will
collide with the previously used reg-id values. This is so the
registrar can replace the older registrations. "
The sequencing of reg-id helps to remove the prev registered contacts,
in case, the UA reboots after crash. Pl correct me.
Should reg-id be same with respect to outbound-proxy-set also?
i.e. The reg-id that is used for Proxy-1 must be same even after reboot.
Say, User first registers with P1 as primary and P2 as secondary and
the reg-id starts from 1. User registers. UA crashes and the user reboots
now with P2 as
primary and P1 as secondary.
i. Should the REGISTER, sent to P2, have reg-id as 2 or
ii. shall it be 1?
Pl clarify.
Thanks in adv.
Best Regards,
Mohammed Hanifa
_______________________________________________
Sip-implementors mailing list
[email protected]
https://lists.cs.columbia.edu/cucslists/listinfo/sip-implementors
