Hi All,
I would like to get advice on this scenario that fails with
3.11.6:
I have 2 ITSP SIP Trunk Gateway accounts each ITSP account will allow a
Maximum of 3 simultaneous calls
I have set up my Dial Plan rule so that both the above SIP trunks have
been added to the rule.
I then "fill" the first SIP Trunk with 3 outgoing calls
I then make a 4th outgoing call it fails with busy tone
The customer expected result is: the 4th call uses the next SIP Trunk
ITSP Gateway defined in the Dial Plan Rule
If we are not going to support this configuration then we will have to
clearly state this in customer Docs i.e. that a dial plan rule with
fallback configured from ITSP trunks to other ITSP trunks is not
supported.
Note I have tested this same dial plan rule scenario using a mix of ITSP
and an ISDN Gateways and that works as expected, i.e. if the ITSP
gateway was full the call fell back to ISDN. Or if the ISDN Gateway was
full the call fell back to the ITSP Gateway
Chris
_______________________________________________
sipx-dev mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
