Hi,
I wanted to shorten the SipX recompilation process and decided to recompile just one module (the sipxregistrar). I installed the SipX 4.0.0 rpms (including the devel rpms) and then I installed the source rpm for sipxregistrar (same release, SRPM area). The compilation went without a hitch. I noticed, however, that the binary (sipxregistrar) is significantly larger than the original (about 600k, the original was about 200k). After installation (sipxregistrar plus the .so files) the component does not start, however. On the management console it is shown as "Failed" without further explanation and it does not write anything into the log (debug level logging). What could have possibly gone wrong? Regards, Gabor **OnRelay Unified MBX -- Replace Desk Phones with Mobiles** --- Gabor Paller, Software Architect OnRelay Elizabeth House | 39 York Road, London SE1 7NQ, UK | +44 (0) 207 902 8151 | [email protected] <mailto:[email protected]> | www.onrelay.com <http://www.onrelay.com/> This electronic message transmission contains information from OnRelay, Ltd., that may be confidential or privileged. The information is intended solely for the recipient and use by any other party is not authorised. If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information or any attachment, is prohibited. If you have received this electronic transmission in error, please notify us immediately by electronic mail ([email protected] <mailto:[email protected]> ) and delete this message, along with any attachments, from your computer. Registered in England No 04006093 | Registered Office 1st Floor, 236 Gray's Inn Road, London WC1X 8HL.
_______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
