On Sun, 2009-10-25 at 07:57 -0400, Scott Lawrence wrote: > If you're using a development build, which is the only way to get this > error, there are at least two ways to avoid this problem: > > 1. Use fully qualified path names when constructing your > installation tree. I believe that the EDE doesn't do this > right now, but it could be fixed to figure out the correct path > and specify it without any dots. > > 2. Take your snapshots from the command line. Anyone using a > development build should be able to handle this.
Using fully qualified path names doesn't avert the problem, as it is the presence of ".." that is detected. But of course, if one has the full path, one can edit it so as to remove the "..". #2 is well-taken. In fact, I always take snapshots from the command line, so I never noticed the problem. (I was investigating XX-6771, which requires taking snapshots from the UI, when I discovered the problem.) At this point, there appears to be no practical reason to fix this problem, so I will close it as "no need to fix right now". If it crops up again, people can find the Jira and reopen it. Dale _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev sipXecs IP PBX -- http://www.sipfoundry.org/
