SipXecs certainly supports video, as it is just a media stream. You can do a video call from a Nortel Phone to a Nortel Phone, or to a Counterpath phone. You can do a counterpath to Polycom as well, using video.
What I haven't seen explained here is what video you are trying to send. What are your endpoints exactly, and what protocol are they expecting, and what are the network requirements? If they are sip based products, then the question is what ports do they require from end to end? You are hard pressed to find many conference systems that use the PSTN for video, unless it is using ISDN PRI or BRI. And, those ports are bonded typically to a higher rate than 64k. I think a bit more detail of what you are trying to do will shed some light on what the technical issues are that need to be overcome, if they can be. In the mean time, you can use some of the proven products - Polycom VVX1500, Nortel, and Counterpath. I did see someone playing with Tanberg on here a few weeks ago as well. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Tony Graziano Sent: Friday, December 10, 2010 5:27 PM To: sipXecs developer discussions Subject: Re: [sipx-dev] Video support in sipXbridge? I normally never have a problem with video. I never find I can call with video through a itsp. I normally have to make a sip-to-sip call or setup a site-ti-site dialing plan. Have you tried to do a sip-to-sip call or site dialing planv On 12/10/10, W. E. W. Russell <[email protected]> wrote: > Yeah, I did that, but still no go. > I was looking into the code and in the RTP*.java files under the bridge and > I get the gist that it doesn't really pay any attention to video codecs. > And what I mean by not pay any attention and why that would be an issue is > that we are seeing that "port unreachable" ICMP error. Since it isn't paying > attention, it never figures out the port it needs to open - I think, correct > me if I'm wrong? > > If copy the section that does it for the audio and make it do the same for > video as well as allow the video codec, that should fix the problem? > > FYI - All the signalling is good and we can hear the voice just fine, no > problem. > > Best regards, > William > > On Fri, Dec 10, 2010 at 7:22 PM, Tony Graziano <[email protected] >> wrote: > >> Have you tried to manually allow the protocol in the allowed list in >> siptrunking (server>services>sip trunking? Or just to remove all >> codecs to allow all? >> >> >> >> On 12/10/10, W. E. W. Russell <[email protected]> wrote: >> > All, >> > >> > We are trying to make a video call to another PBX and it seems that the >> > voice is fine, but there is no video. >> > >> > I did some research and since we were creating a gateway that uses >> > sipXbridge to call it seems that there are some ports that sipXbridge is >> > blocking with ICMP "port unreachable" issues. >> > >> > Again the voice is fine, but the video is getting blocked before it ever >> > leaves the PBX. Thank you for any help you can provide or direction I >> > can >> go >> > in! >> > >> > Best regards, >> > William >> > >> > -- >> > W. E. W. Russell >> > Member of Technical Staff (System Integration) at incNETWORKS, Inc. >> > Alumni of the University of Florida - Fall 2007 - BS in Computer Science >> > Active Alumni member of Sigma Lambda Beta International Fraternity, Inc. >> > Cell Phone # 732-744-6483 >> > Work Phone # 732-483-1511 >> > Blackberry Pin: 30E9FD36 >> > >> >> -- >> Sent from my mobile device >> >> ====================== >> Tony Graziano, Manager >> Telephone: 434.984.8430 >> sip: [email protected] >> Fax: 434.326.5325 >> >> Email: [email protected] >> >> LAN/Telephony/Security and Control Systems Helpdesk: >> Telephone: 434.984.8426 >> sip: [email protected] >> >> Helpdesk Contract Customers: >> http://support.myitdepartment.net >> >> <http://support.myitdepartment.net>Blog: >> http://blog.myitdepartment.net >> >> Linked-In Profile: http://www.linkedin.com/pub/tony-graziano/14/4a6/7a4 >> _______________________________________________ >> sipx-dev mailing list >> [email protected] >> List Archive: http://list.sipfoundry.org/archive/sipx-dev/ >> > > > > -- > W. E. W. Russell > Member of Technical Staff (System Integration) at incNETWORKS, Inc. > Alumni of the University of Florida - Fall 2007 - BS in Computer Science > Active Alumni member of Sigma Lambda Beta International Fraternity, Inc. > Cell Phone # 732-744-6483 > Work Phone # 732-483-1511 > Blackberry Pin: 30E9FD36 > -- Sent from my mobile device ====================== Tony Graziano, Manager Telephone: 434.984.8430 sip: [email protected] Fax: 434.326.5325 Email: [email protected] LAN/Telephony/Security and Control Systems Helpdesk: Telephone: 434.984.8426 sip: [email protected] Helpdesk Contract Customers: http://support.myitdepartment.net <http://support.myitdepartment.net>Blog: http://blog.myitdepartment.net Linked-In Profile: http://www.linkedin.com/pub/tony-graziano/14/4a6/7a4 _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev/ _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev/
