I am having an issue with version sipXconfig (4.4.0- 2011-03-21EDT13:50:34 swift) where the call is disconnected when put on hold twice.
Scenario: We have a cisco 2811 ver IOS15.1 with and ISDN PRI and using it as a sip gateway to SipXecs. User calls in from PSTN Call is answered. Answering user places PSTN call on hold. (MOH is invited but not heard by PSTN user) Answering user resumes call, now MOH is heard along with the voice. Answering user places PSTN call on hold again. MOH is not invited again. 4 seconds later, the call is disconnected. It seems that cisco 2811 disconnects the call because it thinks its a mute call after the second on hold. Also, in SipXecs and on the cisco. The ~~mh~~@ is still active for about 5 minutes. This did not occur on version 4.2.1. Here is the pertinent cisco config: voice call carrier capacity active voice rtp send-recv ! voice service voip allow-connections sip to sip no supplementary-service sip moved-temporarily no supplementary-service sip refer fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711ulaw sip bind control source-interface FastEthernet0/0 bind media source-interface FastEthernet0/0 registrar server expires max 3600 min 3600 ! voice class codec 101 codec preference 1 g711ulaw dial-peer voice 5551212 voip huntstop destination-pattern 5035551212 progress_ind setup enable 3 session protocol sipv2 session target sip-server voice-class codec 101 dtmf-relay rtp-nte ip qos dscp cs5 media no vad sip-ua max-forwards 15 retry invite 3 retry response 3 retry bye 3 retry cancel 3 sip-server dns:uws.edu Does anyone have any ideas? -- Paul Curtis
_______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev/
