On Thu, Jul 2, 2009 at 5:18 PM, Matt Keys<[email protected]> wrote: > > The ITSP told me it was disabled. For S&G's he enabled it for one test call > and then disabled it afterward--it had no effect. This happened before I > forcing G.729 on the phone though. It'll be Monday before I can test with > him again. What do you suggest the next test should be? > > Thanks, > Matt
There is a "use public addressing for call setup" switch that you may want to experiment with. It is on the "advanced" section of the iTSP configuration page. Ranga > > > -----Original Message----- > From: Scott Lawrence [mailto:[email protected]] > Sent: Thu 7/2/2009 4:50 PM > To: Matt Keys > Cc: [email protected] > Subject: Re: [sipx-users] ITSP call goes through but no audio > > There is no rule that says codecs must be the same in both directions. > > I doubt this is your problem - it is much more likely a NAT traversal > issue. Is Covista Communications doing any NAT compensation on their > end - if so, see if you can turn it _off_ so that only one end is > compensating for the NAT. > > > > _______________________________________________ > sipx-users mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users > sipXecs IP PBX -- http://www.sipfoundry.org/ > -- M. Ranganathan _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
