Good morning, I am having an issue with connecting an AudioCodes MP-118 (all FXO) running firmware version 5.60A.024.003 to Sipx 4.0.4-017289 with 8 copper lines. I have a Polycom 550 and Cisco 7960 setup for testing.
Problem #1 I can dial in from the outside and get the AA. From there I try and dial an extension or dial by and the attendant says "please hold why I transfer your call" then a few seconds later the line is disconnected. I am new the sipx world, but as I understand it the problem might be with REFER? Problem #2 Having either of the phones dial out. I have added the gateway and the built in local and long distance dial plans. At one point it would dial out but was send the wrong combo of digits since I kept getting the "please dial 1 and the area code" or some other message that the number was incorrect depending on the configuration at the time. Not sure how to grab a good look at the logs or even what I should be looking for. Any help would be appreciated. Thanks! Andrew _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
