P0S3-08-11-00 is for 7940 and 7960 models, I guess I should have been more detailed.. We are using 7941, 7961 and 7970's with Polycom 3xx series.
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Matt White Sent: Tuesday, April 20, 2010 6:01 AM To: [email protected] Subject: Re: [sipx-users] Cisco and sipX 4.2 >>> On 4/19/2010 at 08:44 PM, in message <e010ecb9aab57a418d87234287233e04efc...@saca-exchange.sacaexchange.local >, "Nathan Nieblas" <[email protected]> wrote: > Ran into some firmware compatibility issues after upgrading from 4.0 to > 4.2 > > > > Firmware 8.3.5 on 79xx would only ring internal extensions but not dial > over the trunk, it would just hang until there was a reorder. > > Firmware 8.5.4 on 79xx works with no known issues so far, however we run > into the Polycom calling the Cisco phone issues again. > > > > Just FYI... If anyone has anything to share Cisco related I'm all ears J > > We are testing 79xx series with P0S3-08-11-00, the only issue we are seeing right now is that the MWI never turns off with 4.2 But we have not seen any of the polycom calling issues or dial over trunk issues in testing....yet -M _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/ _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
