For the 4 corners:
FXO, inbound calls (telco->sip): set up the routing in the 3102 to dial 0 to
go to the AA (if you let north american style callerid (with spaces) through
sipx will drop your calls due to the bad headers from the 3102)
FXO, outbound calls (sip->telco): created an unmanaged gateway pointing at
the 3102 and modified the existing dialplan rules for local and 911 calls to
use it
FXS, inbound calls (sip->phone): I created a user ("205") and programmed in
the resulting sip password in the configuration so the 3102 would register for
inbound calls
FXS, outbound calls (phone->sip): insure that user 205 has permission to
make LD calls outbound.
-Eric
On May 4, 2010, at 11:09 AM, Dave C. Lake wrote:
> Hi Eric,
>
> Thanks for your quick response. Just a few questions though. Is there any
> configuration to be done on the SipXecs side of things. I notice you have
> the PSTN line as 0 where is this setup. How does the dialplan work.
>
> Thanks
>
> Dave
>
>
>
>
> Innovative Business Solutions
> P.O. Box GR5102
> Unit 11, Bois D' Orange Commercial Complex,
> Gros Islet, St. Lucia
> Phone: (758) 4504427
> Fax: (758) 4582759
> Mobile: (758) 7248839
> Email: [email protected]
> Web: www.ibsstlucia.com
>
> -----Original Message-----
> From: Eric Varsanyi [mailto:[email protected]]
> Sent: Tuesday, May 04, 2010 11:41 AM
> To: [email protected]
> Subject: Re: SPA-3000 as PSTN Gateway
>
> Dump of a "working" config below.
>
> The Spa3102 has many problems that no config will fix, it doesn't implement
> the SIP standards properly and Cisco has abandoned it support wise (the
> newest firmware is still broken and is quite old).
>
> The FXS side works more or less, though DTMF may not work depending on your
> ITSP. The FXO side kind of works as long as you don't allow it to import
> caller ID from calls (it corrupts the From: header, though I wrote a patch
> to sipxecs to work around the corruption), there was also a problem with
> REFER that did something bad to the AA.
>
> -Eric
>
>
> On May 4, 2010, at 10:32 AM, [email protected] wrote:
>
>> Hi Eric,
>>
>> I saw your post in the forum where you had setup an SPA -3102 as a PSTN
> gateway. would you happen to have the configuration for this. I am
> attempting to do something similar.
>>
>> Thanks
>>
>> Dave Lake
>
>
>
_______________________________________________
sipx-users mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users
sipXecs IP PBX -- http://www.sipfoundry.org/
