[see the bottom for versions] When I receive a call on a subscribed FXS line on a patton 4114 I can flash and make a 2nd call. The patton manual states that if I then hang up on the second call the first call should 'transfer' to the destination. I've been unable to make this work between FXS ports on the same patton and between a patton fxs and polycom 650's. I flash, get dialtone, call another extension and talk to it normally, but when I hang up the original caller hears only silence and isn't disconnected.
This fails the same if the call is from a patton FXO gateway (another box), another FXS port on the same 4114, or from sipxbridge (voip.ms), or from a Polycom phone. I've tried with the target being a polycom or another FXS on the 4114. I do have the 'call-transfer' option enabled on the FXS interface in the patton. The polycoms do 'referred' and 'blind' transfer as expected in all the above scenarios (call from patton FXS, FXO, ITSP/sipxbridge, or another polycom). I will run traces next, just curious if normal call transfer has ever been known to work with Patton FXS ports or am I just wasting my time? This is sipxecs 4.2. Polycom: 0711224145|app1 |3|00|Application, load: Type=SIP, Version=3.2.3.1734 22-Mar-10 15:56 Patton fxo+fxs: Software Version : R5.4 2009-11-18 H323 SIP FXS FXO Thanks, -Eric _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
