As far as I know, it is possible if you manage mp118 manually via web interface (not via sipxconfig plugin). Try to create a huntgroup on mp118. With "channel select mode", say, ascending. Then in the "endpoint phone number table" you should mark four of your channels to belong to this huntgroup. Then in ip-to-tel route table, route calls to this huntgroup. HTH, Nikolay.
> -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of > Jeff Ferrara > Sent: Thursday, January 27, 2011 3:57 PM > To: [email protected] > Subject: [sipx-users] Audiocodes call handling > > Hello, > > I am using an Audiocodes MP 118 FXO gateway with firmware > 5.60A which is working well with sipXecs 4.2. > > I have a situation where I need to route all outbound (from sipX to > PSTN) calls through only four of the eight gateway line > ports, while keeping all ports available to receive incoming > calls - Is this possible? > > I've been looking through the configuration options, but it > looks like all I can choose is the type of call which gets > sent to the gateway, I don't get any fine control over what > happens when it gets there. > > I guess what I need is a dial plan per gateway port which I > can set to allow / disallow dialing rules, does something > like this exist, or is there another way? > > > Thanks, > Jeff > > _______________________________________________ > sipx-users mailing list > [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users/ _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
