Old thread, but still relevant to me at least. Does anyone have any updated info on paging limits within 4.4? Does the info below still seem accurate? I'm chasing down some issues and I'm not sure if I've run into this as well. My group had 17 in it, but I've got it down to 14 by removing some phones that are near each other. Since the pager doesn't get the page, there are 13 actual destinations on most pages.
On 11/24/2009 5:10 PM, Josh Patten wrote: > Searching from April 2009 to present in the sipx-users list didn't > reveal any paging server information. I was trying to avoid the expense > of installing overhead paging equipment, but if it's necessary I will. > As far as bandwidth goes, generously assuming 100 kbps x 200 extensions, > that's approximately 20 megabits per second, FAR below the gigabit fiber > I will be using. If anything it will be a limitation of the sipX paging > module which as far as I know is limited by CPU speed and RAM, which I > have plenty of. > > I gleaned most of my information from this page: > http://sipx-wiki.calivia.com/index.php/Functional_Specification_for_a_Paging_Server > which is a bit old so may be disconnected from reality. > > If anyone has actually tested this I'd be glad to know. > > Josh Patten > Assistant Network Administrator > Brazos County IT Dept. > > > > > Todd Hodgen wrote: >> There was discussion around this on the list a few months ago, and the >> technical details were provided by one of the developers. There is a limit, >> I don't recall what it is, but it wasn't as high as you are wanting to go >> from what I do recall, but it was higher than 12. I'd check in the old >> archives from the May/June timeframe or there about. >> >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On Behalf Of Josh Patten >> Sent: Tuesday, November 24, 2009 2:02 PM >> To: [email protected] >> Subject: [sipx-users] Paging server performance >> >> Has anyone documented or tested the performance of the paging server? >> The reason I ask is because I am about to do a 200 phone rollout where, >> occasionally, 100 phones will need to be paged at a time. On rare >> occasions all 200 will need to be paged I have a pretty beefy server (8 >> xeon 5500 series cores @ 2.33 GHz each, 16 GB RAM for primary proxy, >> quad-core xeon 5500 2.33 GHz with 2 GB RAM for auxiliary redundant >> proxy) and gigabit fiber to the location. Should I be concerned about >> the performance of the paging server? >> >> > _______________________________________________ > sipx-users mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users > sipXecs IP PBX -- http://www.sipfoundry.org/ _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
