Usually with the Metaswitch they'll need to setup something to send to you on port 5080 udp. You then need to mak 5080 outside to 5080 inside (sipxbridge).
Mike On Fri, Aug 5, 2011 at 1:02 PM, Max DiOrio <[email protected]> wrote: > I'm just getting sipXecs set up with my ITSP, a local provider that uses > a metaswitch at their end. > > > > I have the trunk registered with them and I can place outbound calls > without any issues. However inbound calls aren't even touching my server, > and I'm seeing nothing blocked in my firewall. > > > > VOIP.ms traffic works fine both directions. > > > > Does anyone have any similar metaswitch experience or know where I can > point my ITSP. They did a wireshark of their traffic and they aren't seeing > any problems. Their primary tech supoprt referred it to their switch > support. > > > > I'm just hoping that someone out there can lend some knowledge since I'm > down at this point. > > > > > > _______________________________________________ > sipx-users mailing list > [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users/ > -- Michael Picher eZuce Director of Technical Services O.978-296-1005 X2015 M.207-956-0262 @mpicher <http://twitter.com/mpicher> www.ezuce.com
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
