You might be right, I might have over focused on the from field. This is a new itsp for me and maybe they
require account number in the from field and use something else for CLI. I will have to contact them and get back to you if still problems. Thanks, Sven ________________________________ From: [email protected] [mailto:[email protected]] On Behalf Of Douglas Hubler Sent: 15 August 2011 15:43 To: Discussion list for users of sipXecs software Subject: Re: [sipx-users] Individual CLI not possible 2011/8/15 Sven Evensen <[email protected]> This is an issue I have seen now and then and I also saw mentioned earlier here, but was never resolved. On outbound calls through SIP trunk to ITSP, we want every user to emit own CLI. Normally that will be done in the GW setting with transform extension feature. That works most of the time, NOT here. Alternatively we can set the full CLI in the users's callerID section. That also does NOT work. The only way the outgoing INVITE has anything but the ext number is when I set default caller ID in the GW. But that is not what I want. Unless I missed it, what specific header the SIP message are you expecting to be the user's caller id. Each ITSP can be different on what is uses for caller id to PSTN. sipXbridge config is very confusing here so check each setting on the page, and report them back here. Even the advanced settings. Inspect the SIP message in and out of sipXbridge to identify if the header is goes in wrong or comes out wrong.
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
