On 6/15/2012 12:22 PM, Matt White wrote:
As I stare at my traces I'm seeing an issue with sipxbridge via headers.
The PBX is behind a NAT and has it configured. Calls to the SIP trunk
for external calls are fine.
The gateway that is configured between the PBX and the SeimensPBX are
not separated by nat. The IP address is separated by only a few digits.
The gateway is set to NOT use the public ip for call setup.
However, the via header from sipxbridge to the siemens has the public
ip in the VIA header.
Then when the 200ok comes back the seiemens appends a
"received=privateip" to the via.
I've confirmed the local subnets are correct. I even removed them all
and out in the entire 10.0.0.0/8.
Same problem.
Any thoughts on why sipxbridge is throwing the public ip in the via?
I suspect this might be my issue with the transfer as sipxbridge
should be using the via header to validate the response right?
-M
_______________________________________________
sipx-users mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users/
So the IP address of the SeimensPBX is found in local subnets? Do you
have the Siemens setup as a gateway? Send server profile and reboot sipx?
--
Regards
--------------------------------------
Gerald Drouillard
Technology Architect
Drouillard & Associates, Inc.
http://www.Drouillard.biz
_______________________________________________
sipx-users mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users/
