On Wed, 2003-09-03 at 15:11, Stroehmann, James wrote: > I'm pretty sure this is the expected behavior of system imager. But, when > you set up the image, which networking option did you choose? > static,
Therefore I understood it would take the config files from the image and not from the installenvironment. greetings Kris > -----Original Message----- > From: Kris Buytaert [mailto:[EMAIL PROTECTED] > Sent: Monday, September 01, 2003 4:56 AM > To: '[EMAIL PROTECTED]' > Subject: [Sisuite-users] Interface Switch > > > Hi, > > I just ran into an issue that I couldn't find in the FAQ (might have > overlooked it) > For now I boot the machine with a System Installer CD and a floppy with > a local.cfg, it then configures eth2 and gets an image of the Image > server, (via eth2) Installation works fine. > > > However after booting into it's fresly installed image , it uses the > network configuration from local.cfg on both eth0 and eth1. > Rather than using the value it gets from the image server .. > > Has anybody experienced similar behaviour ? > > I`ll try to dig into the script to see what is actually happening and > why , but I haven't had the time yet. > > greetings.. -- Kris Buytaert [EMAIL PROTECTED] Senior Consultant +32-2-7208835 http://www.stone-it.be/ ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Sisuite-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/sisuite-users
