If you can ping to the router and no further there is a good chance that
Ozemail's router hasn't been configured properly for your range. To check
this monitor modem while you ping an outside domain - if the data is going
out but the receive data light stays unlit it's probably Ozemail - get onto
them and share the hurt! This happened to me with Telstra a few weeks ago
and agonized over it for a day before I realised the problem couldn't be
mine for the above reason.
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Rob Shugg
> Sent: Monday, 10 January 2000 9:22
> To: '[EMAIL PROTECTED]'
> Subject: [SLUG] IP MASQ advice needed
>
>
>
>
> Guys
> I'm in a world of hurt over this. I have read a lot of stuff
> on this and am
> not getting anywhere.
> I can't ping the outside world from my client(local network)
> machine. I can
> ping the router on both 192.168.1.4(I know it should really
> be 192.168.1.1
> by convention)and the ppp0 dynamically assigned IP.
>
> any ideas
>
>
>
> ************router (zardoz) connected to ozemail via ppp0
>
>
> ../rc.local
> .
> .
> .
> echo 1 > /proc/sys/net/ipv4/ip_forward
> #ipchains -P forward DENY
> #ipchains -A forward -p tcp -s 192.168.1.0/24 -j MASQ
> #ipchains -A forward -p udp -s 192.168.1.0/24 -j MASQ
>
>
> etc/hosts
>
>
> 127.0.0.1 localhost localhost.localdomain
> 192.168.1.4 zardoz.home zardoz
> 192.168.1.1 zed1.home zed1
> 192.168.1.2 zed2.home zed2
> 203.108.193.15 ozemail.com.au ozemail
>
>
>
> resolv.conf
>
> search home ozemail.com.au
> nameserver 192.168.1.1
> nameserver 203.2.193.124
> nameserver 203.2.192.124
>
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric
> Ref Use
> Iface
> 192.168.1.4 * 255.255.255.255 UH 0
> 0 0 eth0
> 203.108.193.15 * 255.255.255.255 UH 0
> 0 0 ppp0
> 192.168.1.0 * 255.255.255.0 U 0
> 0 0 eth0
> 127.0.0.0 * 255.0.0.0 U 0
> 0 0 lo
> default 203.108.193.15 0.0.0.0 UG 0
> 0 0 ppp0
> default 192.168.1.254 0.0.0.0 UG 0
> 0 0 eth0
>
> ******************Client (zed2)
>
> /etc/hosts
> 192.168.1.4 zardoz zardoz.home
> 127.0.0.1 localhost localhost.localdomain
> 192.168.1.2 zed2 zed2.home
> 192.168.1.1 zed1 zed1.home
>
>
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric
> Ref Use
> Iface
> 192.168.1.2 * 255.255.255.255 UH 0
> 0 0 eth0
> 192.168.1.0 * 255.255.255.0 U 0
> 0 0 eth0
> 127.0.0.0 * 255.0.0.0 U 0
> 0 0 lo
> default zardoz 0.0.0.0 UG 1
> 0 0 eth0
>
> ../ifcfg-eth0
>
> DEVICE="eth0"
> IPADDR="192.168.1.2"
> GATEWAY="192.168.1.4"
> BROADCAST="192.168.1.255"
> NETMASK="255.255.255.0"
> ONBOOT="yes"
> BOOTPROTO="none"
> IPXNETNUM_802_2=""
> IPXPRIMARY_802_2="no"
> IPXACTIVE_802_2="no"
> IPXNETNUM_802_3=""
> IPXPRIMARY_802_3="no"
> IPXACTIVE_802_3="no"
> IPXNETNUM_ETHERII=""
> IPXPRIMARY_ETHERII="no"
> IPXACTIVE_ETHERII="no"
> IPXNETNUM_SNAP=""
> IPXPRIMARY_SNAP="no"
> IPXACTIVE_SNAP="no"
>
>
>
>
>
> Rob Shugg
> Kinetic Performance Technology
> http://kinetitech.com.au
> [EMAIL PROTECTED]
>
> 23 Banner Street
> O'Connor
> ACT 2602
> Ph 61 408 900 885
> --
> SLUG - Sydney Linux Users Group Mailing List - http://www.slug.org.au
> To unsubscribe send email to [EMAIL PROTECTED] with
> unsubscribe in the text
>
--
SLUG - Sydney Linux Users Group Mailing List - http://www.slug.org.au
To unsubscribe send email to [EMAIL PROTECTED] with
unsubscribe in the text
