On Tue, May 23, 2000 at 02:55:24AM +1000, [EMAIL PROTECTED] wrote:
> The card is supported
> The problem is i am using a BNC connection not a RJ45
You could try the ifconfig setting below, I tried it on my laptop
and it didn't raise an error, but I don't know if it worked or
not.
man ifconfig
media type
Set the physical port or medium type to be used by
the device. Not all devices can change this set�
ting, and those that can vary in what values they
support. Typical values for type are 10base2 (thin
Ethernet), 10baseT (twisted-pair 10Mbps Ethernet),
AUI (external transceiver) and so on. The special
medium type of auto can be used to tell the driver
to auto-sense the media. Again, not all drivers
can do this.
I tried 'ifconfig eth0 192.168.1.1 media 10base2'
--
chesty
--
SLUG - Sydney Linux Users Group Mailing List - http://www.slug.org.au
To unsubscribe send email to [EMAIL PROTECTED] with
unsubscribe in the text
