could have a dodgy harddisk, those 4 gig scsi micropolis drives were very
dodgy....the company doesn't exist anymore either.
since this hdd is a narrow one, it only needs 8 bits terminated, like your
burner, but you might want to set active termination.
hope u got the drive for next to nix :)
--Stephen
-----Original Message-----
From: Arunava Sen [mailto:[EMAIL PROTECTED]]
Sent: Sunday, September 10, 2000 1:04 PM
To: [EMAIL PROTECTED]
Subject: [SLUG] Old scsi hard drive problems.
hi,
i just got an old scsi hard drive. its a micropolis 4341NS. i try to
insmod my scsi card module. my burner is properly detected and stuff but
the hard drive causes problems.
i get (approximately):
---------------
sda: (scsi:0:2:0) No active SCB for reconnecting target.
issuing BUS DEVICE RESET.
---------------
and then i get lots of "timeout" errors.
Anyone have this hard disk or know what is going wrong?
Thanks in advance.
Arun.
--
SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/
More Info: http://slug.org.au/lists/listinfo/slug
