First of all, Slurm is a resource allocator rather than a load
allocator. Slurm allocates CPUs, memory and other resources
exclusively to a job, typically using Linux cgroups. The r1m however
is available. See CPULoad below:
$ scontrol show node
NodeName=jette Arch=x86_64 CoresPerSocket=6
CPUAlloc=0 CPUErr=0 CPUTot=6 CPULoad=0.13 Features=(null)
Quoting Alberto Falzone <[email protected]>:
>
> Hi,
>
> I'm using 2.6.0 version on a very little cluster testbed (2 nodes),
>
> I'm trying to figure out how is possible to get dynamic load informations
> of nodes, i.e.: ut, r15s, r1m, r15m, mem, swp ,
> so they can be shown from "scontrol show nodes" command execution or
> equivalent
> alternative.
> Please, could you suggest me the right configuration or address the
> specific documentation about ?
> Is there any plugin to do that ?
>
> Thanks very much in advance,
>
> Best regards
>
> Alberto
>
>
>
>
>
> --
> Alberto Falzone
> NICE srl
> via Milliavacca, 9
> 14100 Asti (AT) - Italy
> Tel: +39 0141 901516
> Fax: +39 0141 901417
> http://www.nice-software.com
> http://www.enginframe.com
> [email protected]
>
